Run the water which is circulating water bleach from the well to your pressure tank and back to your well through the hose 4.
Bleach in well water.
Wipe the areas you can reach inside the well with bleach solution.
This will help circulate the well water and the chlorine through the whole system to make sure you have thoroughly mixed the chlorine with your water.
Open the vent or remove the test hole plug.
Mix the bleach with 5 to 10 gallons of water and carefully pour it into the well.
Turn off the circuit breaker feeding the pump.
Of bleach for every 18 of standing water in a.
Once you have access to the well carefully pour the correct amount of bleach through.
The sodium hypochlorite active in liquid bleach reacts with the iron and changes it to the chemical form as rust.
For example a well 10 feet deep and 32 inches in diameter requires 3 quarts of chlorine bleach.
The amount of bleach needed depends on the size of the well.
Every few minutes smell the water until you smell chlorine.
This new yellow red discoloration then deposits on clothes and after drying has essentially dyed the clothes.
Pour the liquid bleach down the well cap.
Pour in the bleach.
You may need to start using separate products to treat the wash water supply some folks use ironout since the iron needs to be removed.
2 connect a hose to an outside hose bib and run the water back into the well head for about one to two minutes.
Mix a solution with 1 2 gallon 1 9 l of standard household bleach with 5 gallons 19 l of clean water.
1 carefully pour the diluted bleach solution into the well.
Use water from a garden hose to help the mixture circulate around the well.
Depending on the type of well you may need to open the vent pipe in.
To bleach well water turn off and drain the well system pour chlorine bleach into the well wash the casing and flush the pipes.
Chlorinating the well 1.
If you do not smell any chlorine after 10 minutes add another quart of bleach and continue to circulate the water back into the well.
Wet a cleaning rag in the solution and reach into your well as far as you can to wipe away any residue or contaminants left on the well walls.
The supplies you need for this overnight process include chlorine bleach and a hose.
By pass your filtering system water softener whole house water filters the well s pressure tank and h2o softener.